Get help | Fitting the EcoPro & EcoPro Compact

<Get Help>

The TAPP EcoPro just takes a minute to install following the instructions below.

1. You first remove the aerator in your tap, replace with an adapter (supplied) if required and attach the TAPP EcoPro in place of the aerator.
2. When you remove the aerator from your tap, most likely there is a small washer above it, please use this washer above the adapter supplied with your TAPP.
3. No tools are required for most taps and it only takes a minute to fit.
4. Run the water through the filter for 30 seconds after installation and then you are good to go.

If you get any difficulty please just check these or send an image or video of the issue you experience to +356 99866142

You mixer is a shower type or "a bit different" then check out this and send us a picture of your mixer on +356 99866142 and we can advise. We stock a range of 30+ adapters for the few mixers that need them.

Watch the EcoPro installation video on for for a tap with an aerator having a thread on the inside

 or with threads on the outside

Watch the EcoPro Compact installation video for a tap with an aerator having a thread on the inside

or on the outside